ACS 4.1 MAC Authentication in Network Access Profile

trondaker · ‎10-18-2007

Im configuring Agentless Authentication based om MAC addresses sent from the access switch using MAB (MAC Authent. Bypass). I got it up and running, but with just one MAC address configured in the Authentication rule. When I try to configure more than one address in the rule, I get an error saying this is not a MAC address. How do you separate the MAC entries in the same Authentication rule. The doc says you can configure 10.000 addresses in one rule.

Premdeep Banga · ‎10-18-2007

Please ensure that you are not hitting,

CSCsk27193 : Can't use while entering multiple MAC addresses

Symptom:

Pressing "return" after each MAC address yields error messages when clicking on the "Submit" button while defning authentication configuration for Network Access Profiles Access Policies.

Conditions:

This has been observed on ACS 4.1.1(23) using Internet Explorer 6.0 and JRE 1.5

Workaround:

Separate MAC addresses with a comma (,), do not press "return" after the last MAC address has been entered.

Regards,

Prem