ISDN PRI with a VWIC-1MFT-T1?

Unanswered Question
Oct 18th, 2007

Hello all,

We have a VWIC-1MFT-T1 on a 2821, and have a ISDN PRI circuit. The purpose for this circuit is a failover for remote locations in case their primary link goes down. I was told this VWIC card will work for what we need.

Unfortunately, I have looked everywhere (including Cisco) for configuration guides or examples with no luck. Apparently this is not a common way of working with ISDN PRI.

Is there anyone in a similar scenario? If so, can someone please provide configuration examples or instructions? Thanks,

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Thu, 10/18/2007 - 06:11

Hi,

Support for Data PRI on VWIC-1MFT-T1 has been added to IOS only recently. You would also require PVDM2 modules and this can be incovenient.

This is the configuration guide:

http://www.cisco.com/en/US/products/ps6706/products_feature_guide09186a00805fe293.html

The alternative is to use NM-xCE1T1-PRI that would not require nothing of the above.

hope this helps, please rate post if it does!

Actions

This Discussion