Traffic Shape (2 Mbps IN/OUT on 100 Mbps line)

Unanswered Question
Oct 19th, 2007
User Badges:

Hi everyone,

I have a Cisco 2821 router configured as Internet access router on a 100Mbps line.

The internal i/f of the router is configured as a dot1q trunk to have a VLAN per Internet subnet.

Now I have a guest and I want to give him a static IP address on a Internet VLAN for his VPN router.

The bandwidth for this IP address should be limited to 2Mbps In/Out.

I already tried the traffic shape command but this only for "out"-traffic.

How can I shape the Up- and Downstream traffic?

Thank you in advance.

Best regards,


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Fri, 10/19/2007 - 13:23
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member


you should be able to configure a service-policy with shaping on the subinterface for that vlan, have you tried ?


This Discussion