ISDN<=>VOIP routing help

Unanswered Question
Oct 19th, 2007

hi. ive posted a bit earlier as well, same problem. but now ive advanced a bit.

through all the doc's that ive seen,

all of them have the voice-port interface. i cant get to that command. my ios is 2800NM-IPVOICEK9-M), Version 12.4(15)T1, perhaps im doing something in the wrong order?

what steps do i need to follow next,

in order to be able route my incoming calls to the appropriate phone?

ahh...i didnt mention in my original post how my network is layed out..

i have my cisco router 2811...and anything that comes into it is forwared by nat out the fa0/0 interface where there is a asa5505.

my vlans reside from there on out. my router doesnt have any vlan configurations. the asa5505 take what ever comes into its outside port and forwards it to the appropriate vlan. after the asa 5505 i have a cisco catalyst express500...

so basically, what are the steps (in general or not) that i need to follow to get the voice routed inside.

ive added my bri interfaces so you can have a proper look:

interface BRI0/1/0

no ip address

no logging event link-status

isdn switch-type basic-net3

isdn tei-negotiation first-call

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

trunk-group my-trunk

!

interface BRI0/1/1

no ip address

no logging event link-status

isdn switch-type basic-net3

isdn tei-negotiation first-call

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

trunk-group my-group

thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion