Have a local username and pw setup. then set up priv exec level 0 sh running-config.
But we only get like 10 lines of sh run when logging in as this user.
Tried to go to level 8 and got the same small number of sh run lines. Any ideas what we're doing wrong.?
See in line,
One more question-so the level of cmd's you are able to access is entirely dependent on who you sign in as and what level (or what cmd's)is/are assigned to that user?
---->Yes, that depends on the priv level of user and the commnds
Also, I need to verify for my cust that the question above is correct and applies irregardless of which line you come in on?
---> Line does not matter here. No matter where even user comes from , priv lvl take effect.
Is there any additional granularity you can assign to the VTY's or Con (other than ACL and access-class)?
--->I dont think so.
Do rate helpful posts