extra server on cisco ACS engine

Unanswered Question
Oct 19th, 2007

I'm a bit curious about the way the cisco ACS engine (the cisco-built hardware) sets up servers initially. Most of the documentation I have is for windows, so I was a bit confused when, after the initial configuration there were two "AAA Servers" shown in the configuration, one called "Self" with the IP address I defined, and the other with the name I defined and a different address.

Has anyone else encountered this? Will it cause problems? and is there a way to get rid of it?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Jagdeep Gambhir Fri, 10/19/2007 - 11:16

That is a known issue with acs appliance, but nothing to worry about. Make sure you have this setting in acs,

acs--->network configuration--->Proxy dis table---> Bring Deleverance1 in the fwd to box and your server name in the left box.

Incase you dont see proxy dis table , then you need to enable it

Interface configuration---> Advance option ---> Put a check in distribution table.



Please do rate helpful posts


This Discussion