cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
288
Views
4
Helpful
1
Replies

extra server on cisco ACS engine

netopia
Level 1
Level 1

I'm a bit curious about the way the cisco ACS engine (the cisco-built hardware) sets up servers initially. Most of the documentation I have is for windows, so I was a bit confused when, after the initial configuration there were two "AAA Servers" shown in the configuration, one called "Self" with the IP address I defined, and the other with the name I defined and a different address.

Has anyone else encountered this? Will it cause problems? and is there a way to get rid of it?

Thanks

1 Reply 1

Jagdeep Gambhir
Level 10
Level 10

That is a known issue with acs appliance, but nothing to worry about. Make sure you have this setting in acs,

acs--->network configuration--->Proxy dis table---> Bring Deleverance1 in the fwd to box and your server name in the left box.

Incase you dont see proxy dis table , then you need to enable it

Interface configuration---> Advance option ---> Put a check in distribution table.

Regards,

~JG

Please do rate helpful posts

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: