Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
868
Views
0
Helpful
3
Replies

IP For stp

ayussuf
Level 1
Level 1

‎10-22-2007 07:56 AM - edited ‎03-05-2019 07:14 PM

Hi

I have ip address on vlan 1 on all my switchs and I want to change the scope. I have Stp running on all. I I were to go aroung chenging one by one, will it affect my live network? Does STP use Ip address at all?

Labels:
0 Helpful
3 Replies 3

Francois Tallet
Level 7
Level 7

‎10-22-2007 08:46 AM

STP is purely an L2 stuff, so your IP readdressing will have absolutely no impact on it. The only interaction between STP and IP that comes to my mind is SNMP traps;-) So nothing to worry about STP convergence in that case.

Regards,

Francois

0 Helpful

ankbhasi
Cisco Employee
Cisco Employee

‎10-22-2007 08:49 AM

Hi Ayus,

STP being a layer 2 protocol is not related to change of ip address. Change if ip address may affect your routing table and may have an affect on layer 3 convergance but not stp.

STP will be affected if some physical port goes down and come back or if switch itself reloads or any change in stp default timers and parameters.

HTH

Ankur

*Pls rate all helpfull post

0 Helpful

ayussuf
Level 1
Level 1
In response to ankbhasi

‎10-22-2007 09:53 AM

Thansk guys

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card