Solved: RSPAN, SPAN and general monitoring techniques

brandon.n · ‎10-22-2007

I have a dilemma. I need to monitor 4 links. for inbound and outbound traffic. A hub is out of the question as traffic won't be seperated. Currently I am using a product called nTap to tap the four links back to a Cisco switch. The problem is SPAN only allows for 2 sessions. So 2 links can't be monitored. Attached is a diagram. Would RSPAN be better? Is RSPAN easier to configure? What exactly is VSPAN and when would it be best applicable?

Kevin Dorrell · ‎10-23-2007

So, create an RSPAN VLAN and make sure it goes wherever you need it.

Then, on the switch(es) you want to source from:

monitor session 1 source interface f2/2 options

monitor session 1 source interface f2/8 options

etc

monitor session 1 destination remote vlan 40

exit

show monitor

On your sniffing switch

monitor session 1 source remote vlan 40

monitor session 1 destination interface f0/4

exit

show monitor

Kevin Dorrell

Luxembourg

View solution in original post

brandon.n · ‎10-23-2007

Bump.

Kevin Dorrell · ‎10-23-2007

I am sure this will be possible.

Generally, it is not one session per port source monitored. Each session can monitor several ports in the switch.

But before I give you a load of configs that you cannot use, what sort of switches are you working with: IOS or CatOS. And what model?

Kevin Dorrell

Luxembourg

brandon.n · ‎10-23-2007

Thanks Kevin... we have any switch you can name. Preferably I want to do it on a 3550 but a 3750 is okay as well. IOS version only, no CatOS.

Kevin Dorrell · ‎10-23-2007

So, create an RSPAN VLAN and make sure it goes wherever you need it.

Then, on the switch(es) you want to source from:

monitor session 1 source interface f2/2 options

monitor session 1 source interface f2/8 options

etc

monitor session 1 destination remote vlan 40

exit

show monitor

On your sniffing switch

monitor session 1 source remote vlan 40

monitor session 1 destination interface f0/4

exit

show monitor

Kevin Dorrell

Luxembourg

brandon.n · ‎10-23-2007

Excellent Kevin.. I will try this. Your help is greatly appreciated :)

Konstantin Dunaev · ‎10-23-2007

don't forget that on low-end switches eg. 2950, 2970 you need the mirror port to configure the RSPAN session. that ports should no be used and should not be in "disable" status.