cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
340
Views
2
Helpful
4
Replies

Setup Access to the Internet on 1811W on the switch side

rmakarious
Level 1
Level 1

I have setup the internet on the Wan port Fastert0/1, can ping successfully public ip address however when connecting PC on the switch side ( The router has two wan interfaces and 6 switch ports) pc configured with 192.168.0.17 255.255.255.0 default gate way 192.168.0.250 ( router's lan address) i can not get through to the internet

4 Replies 4

lgijssel
Level 9
Level 9

Best would be to see your config but I can give you a few suggestions anyway:

1: Is NAT configured correctly on the router?

2: Did you configure a default route to the Internet?

3: Is there a valid DNS configured on the PC?

Please feel free to post any additional questions or information.

regards,

Leo

nat is configured

the default route is configured to the internet

there is vaild DNS

OK, so this a Cisco1800 series router with wireless. I recently configured one of these myself which is working perfectly.

I have to be off in a few minutes but when I get back I will compare the two configs and keep you posted. You seem to be quite close already.

Leo

Guessed I would help you most by posting my working config. Here it is.

Saves me some time as well ;-)

regards,

Leo

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: