cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1098
Views
0
Helpful
3
Replies

https/ssl with CiscoWorks Browser

r.schlifke
Level 1
Level 1

Is is possible to configure secured CW browser access using https or ssl certificates?

Thanks,

1 Accepted Solution

Accepted Solutions

There are no such things as CS 2.5 and 2.6, so I will assume you mean CS 3.0 for LMS 2.5 and 2.6. For LMS 2.2, you can only enable SSL mode if you do not have DFM installed. To enable SSL mode, go to Server Configuration > Administration > Security Management > Enable/Disable SSL.

For LMS 2.5 and higher, SSL can always be enabled. To do this, go to Common Services > Server > Security > Browser-Server Security Mode Setup.

View solution in original post

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

Absolutely. What version of CiscoWorks are you using?

Thanks for the reply!

We are using CW Common Services 2.2, 2.5, and 2.6 on Windows 2000 and Solaris servers.

Thanks again,

Bob Schlifke

There are no such things as CS 2.5 and 2.6, so I will assume you mean CS 3.0 for LMS 2.5 and 2.6. For LMS 2.2, you can only enable SSL mode if you do not have DFM installed. To enable SSL mode, go to Server Configuration > Administration > Security Management > Enable/Disable SSL.

For LMS 2.5 and higher, SSL can always be enabled. To do this, go to Common Services > Server > Security > Browser-Server Security Mode Setup.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: