Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
437
Views
0
Helpful
3
Replies

Recover router

gautamzone
Level 1
Level 1

‎10-24-2007 04:06 AM - edited ‎03-05-2019 07:16 PM

Dear All,

While doing a password recovery on 2691 router, i accidentally changed the config register value to 0x2162 instead of 0x2142. Now i get all junk while booting the router.

Is there a way where i can undo this mistake?

Thanks a lot

Gautam

Labels:
0 Helpful
3 Replies 3

Kevin Dorrell
Level 10
Level 10

‎10-24-2007 04:34 AM

Yes, try different baud rates on the terminal until you get the right one. If I have calculated right, 19200 should do the trick.

http://www.cisco.com/en/US/partner/docs/routers/access/2600/hardware/installation/guide/2600appC.html

Kevin Dorrell

Luxembourg

0 Helpful

smothuku
Level 7
Level 7

‎10-24-2007 04:36 AM

Hi Gautham ,

Chnage the baud rate starting from Min. value to Max.value and check whether you are getting rommon mode at one particular value.

Thanks,

satish

0 Helpful

gautamzone
Level 1
Level 1
In response to smothuku

‎10-24-2007 07:34 AM

Thanks a lot for your kind inputs. I will let you know.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card