Remote access using Robotics modem

Unanswered Question
Oct 24th, 2007
User Badges:

Hi,looking for advice to connect to various 1700,2500,&3600 series routers via dialup. I get window, but no prompt. I've done following:


. changed cable (router to modem)

. reset options on modem

. rebooted router and modem

. cleared line aux 0


Any ideas, would appreciate the help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
felixarrow1 Wed, 10/24/2007 - 10:13
User Badges:

Here is config:


line aux 0

password xxx

autobaud

script startup aux

login

modem InOut

transport input all

flowcontrol hardware



CLI output on AUX 0:


Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns

1 AUX 2400/2400 F inout - - - 0 0 0/0


Line 1, Location: "", Type: ""

Length: 24 lines, Width: 80 columns

Baud rate (TX/RX) is 2400/2400, no parity, 2 stopbits, 8 databits

Status: No Exit Banner

Capabilities: Autobaud Full Range, Hardware Flowcontrol In,

Hardware Flowcontrol Out, Modem Callout, Modem RI is CD

Modem state: Idle

Modem hardware state: CTS* noDSR DTR RTS

Special Chars: Escape Hold Stop Start Disconnect Activation

^^x none - - none

Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch

00:10:00 never none not set

Idle Session Disconnect Warning

never


Hyperterm is set at 8,N,1 tried various speeds from 2400 - 38400


Actions

This Discussion