10-25-2007 10:16 PM - edited 03-05-2019 07:20 PM
Hello,
Wondering if some kind expert will help me out.
In IPv6, it is possible to assign multiple IPv6 addresses to an interface. What about when you tunnel IPv6 over IPv4?
I noticed that when I had two IPv6 addresses mapped to one end of the tunnel, the tunnel was up, but I could not ping the other end.
10-30-2007 10:24 AM
Jason,
Not sure whether this is normal behavior or not. May I ask what is the purpose of specifying two addresses on the tunnel interfaces.
Regards,
11-25-2007 05:09 PM
No particular purpose. It was to better understand whether the tunnel behaved similarly to a regular interface in IPv6, given that in IPv6 you can assign multiple IPv6 addresses to an interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: