using 2 bri ports for voice

Unanswered Question
Oct 27th, 2007

I have 2 bri ports (4 channels) using callmanager express,that are used with a main number incoming, no DDI's. Does anyone know of the best way to get outbound dial-peers to use both ports?

I can only configure 1 port on the dial-peer, I have 24 dial-peers and want to avoid duplicating them so that I have 48 dial-peers.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Paolo Bevilacqua Sat, 10/27/2007 - 05:08

Use trunk-group:

int bri x/y

trunk-group pots

dial-peer voice 100 pots

destination-pattern 9...T

trunkgroup pots

you can also apply translations to the trunk-group, change the order channels are used, etc.

Hope this helps, please rate post if it does!

Actions

This Discussion