cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
272
Views
5
Helpful
3
Replies

using 2 bri ports for voice

silex
Level 1
Level 1

I have 2 bri ports (4 channels) using callmanager express,that are used with a main number incoming, no DDI's. Does anyone know of the best way to get outbound dial-peers to use both ports?

I can only configure 1 port on the dial-peer, I have 24 dial-peers and want to avoid duplicating them so that I have 48 dial-peers.

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

Use trunk-group:

int bri x/y

trunk-group pots

dial-peer voice 100 pots

destination-pattern 9...T

trunkgroup pots

you can also apply translations to the trunk-group, change the order channels are used, etc.

Hope this helps, please rate post if it does!

many thanks,

I shall give it a try

Thanks for the nice rating and good luck!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: