10-27-2007 04:51 AM - edited 03-15-2019 04:56 AM
I have 2 bri ports (4 channels) using callmanager express,that are used with a main number incoming, no DDI's. Does anyone know of the best way to get outbound dial-peers to use both ports?
I can only configure 1 port on the dial-peer, I have 24 dial-peers and want to avoid duplicating them so that I have 48 dial-peers.
10-27-2007 05:08 AM
Use trunk-group:
int bri x/y
trunk-group pots
dial-peer voice 100 pots
destination-pattern 9...T
trunkgroup pots
you can also apply translations to the trunk-group, change the order channels are used, etc.
Hope this helps, please rate post if it does!
10-27-2007 07:53 AM
many thanks,
I shall give it a try
10-27-2007 10:24 AM
Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: