Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
333
Views
0
Helpful
1
Replies

CM 5.x/6.x Trunk to SIP Provider

Go to solution
toddcarp123
Level 1
Level 1

‎10-27-2007 05:28 AM - edited ‎03-15-2019 04:56 AM

Apparently CM 5.x and 6.x can function as a SIP UAC, but I cannot get it to do so. I have the SIP trunk, SIP security, SIP profile and SIP realm in place, but no luck. I am comparing sniffer traces of a working softphone connection vs the CM attempts and the CM is not passing any REGISTER attempts and the the INVITES on outbound call requests are missing the authorization information. Any assistance would be appreciated. Thanks.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
jhinton
Level 4
Level 4

‎10-30-2007 08:59 AM

I know from experience that CM 6.X can act as a SIP UAC but does not support SIP REGISTER. If you need to support SIP REGISTER you have to offload this onto another device.

Digest authentication is supported and you configure credentials under User Management>SIP Realm

View solution in original post

0 Helpful
1 Reply 1

Go to solution
jhinton
Level 4
Level 4

‎10-30-2007 08:59 AM

I know from experience that CM 6.X can act as a SIP UAC but does not support SIP REGISTER. If you need to support SIP REGISTER you have to offload this onto another device.

Digest authentication is supported and you configure credentials under User Management>SIP Realm

0 Helpful
Customers Also Viewed These Support Documents