10-29-2007 09:21 AM
I've configured netflow to export data to a correct ip and port number. I doubled and tripled check both sides. And both show the the destination ip and port is ok. SNMP community is doubled check and everything on that side is ok. When I run the sho ip flow ex it comes up with 0's. Any suggestions?
10-29-2007 05:59 PM
You don't mention what device(s) or IOS versions you are running, but basically you need enter either of the following commands on each of your L3 interfaces.
ip route-cache flow
or
ip flow {ingress | egress}
HTH
Steve
10-30-2007 03:14 AM
I did the ip flow ingress egress and enabled the interface itself and everything worked great. thx
10-30-2007 01:30 AM
Hello,
could you send me your netflow configuration?
i.e.:
show running | inc flow
show running | inc mls
Kind regards,
Jan Nejman
Caligare, Co.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide