10-29-2007 09:21 AM
I've configured netflow to export data to a correct ip and port number. I doubled and tripled check both sides. And both show the the destination ip and port is ok. SNMP community is doubled check and everything on that side is ok. When I run the sho ip flow ex it comes up with 0's. Any suggestions?
10-29-2007 05:59 PM
You don't mention what device(s) or IOS versions you are running, but basically you need enter either of the following commands on each of your L3 interfaces.
ip route-cache flow
or
ip flow {ingress | egress}
HTH
Steve
10-30-2007 03:14 AM
I did the ip flow ingress egress and enabled the interface itself and everything worked great. thx
10-30-2007 01:30 AM
Hello,
could you send me your netflow configuration?
i.e.:
show running | inc flow
show running | inc mls
Kind regards,
Jan Nejman
Caligare, Co.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: