ASA 5500 U-turn

Unanswered Question
Oct 29th, 2007
User Badges:

Hi,

I am trying to set up an ASA 5500 to do some routing. We have a couple of networks on the inside, and I am trying to use the router as the gateway address for one of them. It has routes to all the networks and I added the " same-security-traffic permit intra-interface" command gut that did not work. Am I missing something?

Thank you,


Joel Friedman

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Mon, 10/29/2007 - 11:29
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Joel


At the risk of stating the obvious, the interfaces do actually have the same security level ?


If so it could be a NAT issue - could you post config if at all possible.


Jon

jfriedman Mon, 10/29/2007 - 11:35
User Badges:

I am coming in and out of the same interface (inside). I am not sure if I can post the configuration, even sanitized, as it belongs to a customer of mine.

Joel

acomiskey Mon, 10/29/2007 - 11:38
User Badges:
  • Green, 3000 points or more

This should be one way to get it going...


security-traffic permit intra-interface

global (inside) 1 interface

nat (inside) 1 0 0

Actions

This Discussion