10-29-2007 11:24 AM - edited 02-21-2020 01:44 AM
Hi,
I am trying to set up an ASA 5500 to do some routing. We have a couple of networks on the inside, and I am trying to use the router as the gateway address for one of them. It has routes to all the networks and I added the " same-security-traffic permit intra-interface" command gut that did not work. Am I missing something?
Thank you,
Joel Friedman
10-29-2007 11:29 AM
Joel
At the risk of stating the obvious, the interfaces do actually have the same security level ?
If so it could be a NAT issue - could you post config if at all possible.
Jon
10-29-2007 11:35 AM
I am coming in and out of the same interface (inside). I am not sure if I can post the configuration, even sanitized, as it belongs to a customer of mine.
Joel
10-29-2007 11:38 AM
This should be one way to get it going...
security-traffic permit intra-interface
global (inside) 1 interface
nat (inside) 1 0 0
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide