10-29-2007 03:21 PM - edited 03-13-2019 04:36 PM
Anyone else seen this on CM 5.1.2?
When dialing a digit, then pressing the AbbrDial softkey, user gets the message "number not configured" Same message for speed dial entries that have, or have not been populated.
Never failed me prior to 5.x so I may have missed something in the new screens. Any ideas before I open a TAC case. thanks.
11-02-2007 01:54 PM
You could be hitting with a bug : check the details of this bug: CSCsj41921
12-19-2007 10:27 AM
Wasn't that bug.
Rebooting the Publisher fixed it. go figure...
02-15-2008 08:28 AM
Hello guys,
I am facing the same problem and have rebooted the Publisher but no success. I have only one abbraviated number configured and get the following error message "Number not configured". Do you guys have any idea what could be wrong?
Thanks,
MK
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: