IDSM-2 Re-Image

Unanswered Question
Oct 30th, 2007

I've ran in troubles after IDSM booted up into maintenance partition. IDSM-2 is refusing session from switch running native IOS and unresponsive. Any quick solution for this problem? TAC is the only resort / could be a HW problem?

1#ses slot 2 proc 1

The default escape character is Ctrl-^, then x.

You can also type 'exit' at the remote prompt to end the session

Trying ...

% Connection refused by remote host

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

2 0003.xxxx.xxxx to 0003.xxxx.xxxx 4.0 7.2(1) 1.3(2)m Ok


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
irisrios Mon, 11/05/2007 - 07:14

There is no problem with the hardware. Changing the boot parameter from cf:1 to hdd:1 worked for me 1.e from Flash to hard disk


This Discussion