configuring 100mb fiber Point-to-Point between 2 3560G-12s

Unanswered Question
Oct 30th, 2007
User Badges:

Any suggests on how to configure this, have any idea but just need to confirm. Currently have a T1 configured between the two sights.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (3 ratings)
Loading.
Collin Clark Tue, 10/30/2007 - 08:58
User Badges:
  • Purple, 4500 points or more

Depends, do want it layer 2 or layer 3? Either way it's configured just like any other uplink between two switches. You will want to keep a couple of things in mind like STP and UDLD.


HTH and please rate.



brosebro Tue, 10/30/2007 - 09:45
User Badges:

I will be doing STP. would I set spanning-tree link-type point-to-point?

Collin Clark Tue, 10/30/2007 - 09:51
User Badges:
  • Purple, 4500 points or more

You can but it is not required.


HTH and please rate.

brosebro Tue, 10/30/2007 - 10:05
User Badges:

OK, this is what I have for both sides and looks to me it should work. just need a second opinion?


sw# 1

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 5,10,12,20-28,30,50

switchport mode trunk

srr-queue bandwidth share 10 10 60 20

srr-queue bandwidth shape 10 0 0 0

queue-set 2

mls qos trust cos

auto qos voip trust



sw#2


switchport trunk encapsulation dot1q

switchport mode trunk

srr-queue bandwidth share 10 10 60 20

srr-queue bandwidth shape 10 0 0 0

queue-set 2

mls qos trust cos

auto qos voip trust

Collin Clark Tue, 10/30/2007 - 10:09
User Badges:
  • Purple, 4500 points or more

Looks OK. Might want to hard set speed/duplex and enable UDLD (I don't remember if that shows up per interface or globally).



Actions

This Discussion