cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
527
Views
0
Helpful
2
Replies

applying service policy using radius and VPDN

liamkennedy
Level 1
Level 1

anyone had any success doing this?

I've been following the suggested config at http://www.cisco.com/en/US/customer/products/ps6566/products_feature_guide09186a0080610dad.html#wp1058626 but not having any success.

sessions terminate on my 7301 via L2TP through another provider - this all works fine.

I have the following AVPair defined in the user RADIUS profile:

Cisco-AVPair = "ip:sub-qos-policy-out=DROP-P2P"

and the matching policy map defined on the 7301 but it does not get applied to the user session.

Debug L2X errors gives the following message:

001867: Oct 30 16:12:50.655 UTC: L2X: Unknown AVP 76 in CM SCCRQ

001868: Oct 30 16:12:50.655 UTC: L2X: Ignoring unknown AVP 76

if I apply the policy map in the virtual-template it does get applied, but obviously to all users on that template which is not what I want.

edit: - btw the 7301 is on 12.4 so this feature should be available.

thanks

Liam.

2 Replies 2

tstanik
Level 5
Level 5

With a router it won't be possible to get different policy for users in a single template. Following link may help you

http://www.cisco.com/en/US/customer/products/ps6566/products_feature_guide09186a0080610dad.html#wp1081783

thats the same document I referenced in my original question and its states clearly "You can choose to configure the feature using either a virtual template or a RADIUS server."

If you add the policy to the virtual template it will apply to all users, if you use RADIUS you (should) be able to apply policies on a user-by-user basis.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: