10-30-2007 09:22 AM - edited 03-13-2019 04:37 PM
I am trying to add a new CTI route point in ccm 5.0.2 and it won't reg w/cm. I am not able to add any new CTI RP.
What is causing this? Phones are registering just fine.
10-30-2007 09:33 AM
Hi Chris,
Have a look at this post from one of my faves NetPro Shanky!
http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dde5268/2#selected_message
Hope this helps!
Rob
10-30-2007 09:45 AM
I am trying to setup transfer directly to voice mail. I don't understand what application would tie to CTI?
10-30-2007 10:29 AM
For direct transfer to voicemail. Just create a RP, and create *XXXX (if you are using 4 digits) and forward all the calls to VM pilot.
That should do it.
10-30-2007 10:49 AM
yes, that is what I have done. The CTI RP won't register.....
10-30-2007 11:54 AM
As shankar & rob suggested, CTI RP in this one it wouldnt register.
CTI RP only registers with Mobility MAnagaer, IPMA & Attendant Console
10-30-2007 12:05 PM
And IPCC as well
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
