Unable to NAT out

Unanswered Question
Oct 30th, 2007

Out/In

DSL (DHCP for vlan2) 192.168.1.1

FW ports 0,6,7 are on vlan2

vlan2 is 192.168.1.2

INSIDE: 10.25.0.x (vlan1)

ACL is set to allow all 10.25.0.x traffic out.

NAT is configured to allow all 10.25.0.0 to 192.168.1.1

Inside is only able to ping the 10. traffic, unable to ping out even with icmp active.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
santukumar Tue, 10/30/2007 - 22:52

If u want to access the internet, then u have to do these config to add--

nat (inside) 1 0 0

global (outside) 1 interface

after issuing these commands, u will be able to go to the internet.

rj45lanman Wed, 10/31/2007 - 09:29

The other problem was not being able to ping anything on the inside net. I placed an acl stating: source-192.168.1.0 destination-10.25.0.2 to allow all icmp.

Actions

This Discussion