Cannot configure ft vlan interface on ACE v3.0.0.A1.6.2

Answered Question

When I follow directions to configure FT on my ACEs at:


http://cisco.com/en/US/products/hw/modules/ps2706/products_configuration_guide_chapter09186a0080683a15.html#wp999520


If you go to Table 7-1 on step 4. I cannot configure the vlan interface. When I type: "interface vlan 100", I get the error:


Error: vlan 8 is marked for FT use; modification not allowed


I tried just skipping that step and went to my second ace in another 6500 switch and did all the other steps but vlan8 doesn't show up in "show vlans" and I cannot sync my configs. Anyone knoww hat the deal is?


Correct Answer by Syed Iftekhar Ahmed about 9 years 6 months ago

you need to assign vlans to other ACE (on other Cat) as well. You need a minimum config on the other ACE that includes


ft interface

ft peer

and

ft group commands


Syed


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Ok I found the vlan issue was I entered the svclc vlan-group command before I created the vlan. I took out the vlan-group settings and put them back in and now vlan 100 is showing up on the ace. I still cannot see the peer ACE.


lax-core-ace1/Admin# sh ft stats

HA Heartbeat Statistics

------------------------


Number of Heartbeats Sent : 22499

Number of Heartbeats Received : 0

Number of Heartbeats Missed : 22499

Number of Unidirectional HB's Received : 0

Number of HB Timeout Mismatches : 0

Num of Peer Up Events Sent : 0

Num of Peer Down Events Sent : 1


Correct Answer
Syed Iftekhar Ahmed Tue, 10/30/2007 - 22:42
User Badges:
  • Blue, 1500 points or more

you need to assign vlans to other ACE (on other Cat) as well. You need a minimum config on the other ACE that includes


ft interface

ft peer

and

ft group commands


Syed


Syed Iftekhar Ahmed Tue, 10/30/2007 - 23:25
User Badges:
  • Blue, 1500 points or more

There was a 5.6 quake 2 hrs ago here in BayArea

Hard to go to bed :) .


Syed

Actions

This Discussion