10-30-2007 11:55 PM - edited 03-03-2019 05:34 AM
Hi
Can i perform policy based routing with 4503 switch having SUP II + TS or i need to have router to perform this PBR? kindly provide links to the documentation if possible.
regards
10-31-2007 12:17 AM
Hi Ahmad,
Sup2+ will support PBR only till 12.2(25)SG. Starting 12.2(25)SG the SupII+ will NOT work with the Enhanced (enterprise services)image which is required for PBR. Sup2+ has a smaller TCAM capacity.
http://www.cisco.com/en/US/customer/products/hw/switches/ps4324/prod_bulletin0900aecd8030c501.html
Please refer to the product bulletin..Look in Table 1.
http://www.cisco.com/en/US/customer/products/hw/switches/ps4324/prod_bulletin0900aecd8030c501.html
HTH
Ankur
*Pls rate all helpfull post
10-31-2007 12:23 AM
hi Ankur
thanks for your reply. so that means,i cant perform PBR using this SUP engine.I need to have Router to perform PBR.
I need to route VPN traffic to specific path and MPLS traffic to other route.
thanks once again
10-31-2007 01:12 AM
Hi Ahmad,
Yes if your sup is running image which I specified in my previous post then sup2+ cannot do PBR and if you have a router then you have to use the router for the same.
Regards,
Ankur
*Pls rate all helpfull post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: