Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
985
Views
5
Helpful
2
Replies

Rate limit on a fast ethernet interface

VictorAKur
Level 1
Level 1

‎10-31-2007 03:08 AM

Hi

I am trying to configure a rate limit on an interface on a 2948 box with 12.0(7)W5(15a) software on it, so that it limits all traffic to 2mbs on a 10 mbs point to point link.

I have configured it as

#rate-limit input 2000000 375000 750000 conform-action transmit exceed-action drop

#rate-limit output 2000000 375000 750000 conform-action transmit exceed-action drop

but when we tried to run iperf on both ends of the link it went through at full 10mbs.

Any ideas anyone?

Labels:
0 Helpful
2 Replies 2

steve.busby
Level 5
Level 5

‎10-31-2007 05:46 PM

From the release notes, I don't think QoS or rate-limiting was fully-baked until 12.0(10)W5(18e):

http://www.cisco.com/en/US/docs/switches/lan/catalyst2948gand4908g/release/note/OL_2351.html#wp44161

Maybe a code upgrade would help?

HTH

Steve

VictorAKur
Level 1
Level 1
In response to steve.busby

‎11-01-2007 07:25 AM

Thank you very much - got 12.0(25) and it all works.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents