10-31-2007 03:08 AM
Hi
I am trying to configure a rate limit on an interface on a 2948 box with 12.0(7)W5(15a) software on it, so that it limits all traffic to 2mbs on a 10 mbs point to point link.
I have configured it as
#rate-limit input 2000000 375000 750000 conform-action transmit exceed-action drop
#rate-limit output 2000000 375000 750000 conform-action transmit exceed-action drop
but when we tried to run iperf on both ends of the link it went through at full 10mbs.
Any ideas anyone?
10-31-2007 05:46 PM
From the release notes, I don't think QoS or rate-limiting was fully-baked until 12.0(10)W5(18e):
http://www.cisco.com/en/US/docs/switches/lan/catalyst2948gand4908g/release/note/OL_2351.html#wp44161
Maybe a code upgrade would help?
HTH
Steve
11-01-2007 07:25 AM
Thank you very much - got 12.0(25) and it all works.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: