CCME to External Gateway Example

Unanswered Question
Oct 31st, 2007
User Badges:

I have a 2811 router running CCME/CUE along with another 2821 router that has a PRI circuit. I have my phones registered to the CCME and I can make calls between them but I am new to this and I was hoping someone would know of some examples of how to get my phones to use the PRI on the 2821.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
paolo bevilacqua Wed, 10/31/2007 - 05:05
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

On the router without PRI:


dial-peer voice 100 voip

destination-pattern 9T

session target ipv4:

dtmft-relay cisco-rtp



Calling 9 they will get to the other router. Of course choose a same digit for calling out.


Hope this helps, please rate post if it does!

h.parsons Wed, 10/31/2007 - 05:11
User Badges:

What about on the router with the PRI, how do I route incoming calls to the phones?

paolo bevilacqua Wed, 10/31/2007 - 05:19
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You don't need anything on the terminating. Just configure an additional voip DP on the originating, with eg destination-patter 7... and using the same session target.



Actions

This Discussion