10-31-2007 04:57 AM - edited 03-13-2019 04:38 PM
I have a 2811 router running CCME/CUE along with another 2821 router that has a PRI circuit. I have my phones registered to the CCME and I can make calls between them but I am new to this and I was hoping someone would know of some examples of how to get my phones to use the PRI on the 2821.
10-31-2007 05:05 AM
On the router without PRI:
dial-peer voice 100 voip
destination-pattern 9T
session target ipv4:
dtmft-relay cisco-rtp
Calling 9 they will get to the other router. Of course choose a same digit for calling out.
Hope this helps, please rate post if it does!
10-31-2007 05:11 AM
What about on the router with the PRI, how do I route incoming calls to the phones?
10-31-2007 05:19 AM
You don't need anything on the terminating. Just configure an additional voip DP on the originating, with eg destination-patter 7... and using the same session target.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide