10-31-2007 01:32 PM - edited 03-03-2019 05:36 AM
If I am to understand this correctly...our buffers are getting full (likely because the device this router is attached to can not keep up)?
Public buffer pools:
Small buffers, 104 bytes (total 50, permanent 50, peak 99 @ 2w1d):
46 in free list (20 min, 150 max allowed)
7935483 hits, 2020 misses, 1826 trims, 1826 created
332 failures (0 no memory)
Middle buffers, 600 bytes (total 25, permanent 25, peak 43 @ 5w4d):
24 in free list (10 min, 150 max allowed)
2828619 hits, 337 misses, 232 trims, 232 created
85 failures (0 no memory)
Big buffers, 1536 bytes (total 50, permanent 50):
50 in free list (5 min, 150 max allowed)
227997 hits, 0 misses, 0 trims, 0 created
0 failures (0 no memory)
VeryBig buffers, 4520 bytes (total 10, permanent 10):
10 in free list (0 min, 100 max allowed)
0 hits, 0 misses, 0 trims, 0 created
0 failures (0 no memory)
Large buffers, 5024 bytes (total 0, permanent 0):
0 in free list (0 min, 10 max allowed)
0 hits, 0 misses, 0 trims, 0 created
0 failures (0 no memory)
Huge buffers, 18024 bytes (total 1, permanent 0, peak 2 @ 3w4d):
1 in free list (0 min, 4 max allowed)
16 hits, 1 misses, 231 trims, 232 created
0 failures (0 no memory)
10-31-2007 01:58 PM
Have you tried buffer tuning ?
http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a00800a7b80.shtml
11-01-2007 02:33 PM
Carbon based error on our end.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide