Sh mac-address command in Cisco RSP4

Unanswered Question
Oct 31st, 2007
User Badges:

Hello guys,


Need your ideas on how to know to which port a device connected to using mac-address information on Cisco DLSw RSP4.

I did tried using command "sh mac-address add" but it is not recognized in this IOS.

See below outputs:


RSP-Core#sh ver

Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-DSV-M), Version 12.1(13), RELEASE SOFTWARE (fc3)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Wed 30-Jan-02 13:58 by kellythw

Image text-base: 0x60010958, data-base: 0x61186000

.....

cisco RSP4 (R5000) processor with 131072K/2072K bytes of memory. >>>>>>>>>

R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache



RSP-Core>sh ip arp tok 1/1/0

Protocol Address Age (min) Hardware Addr Type Interface

Internet 146.X.3.76 5 0060.9435.63e2 SNAP TokenRing1/1/0

Internet 146.X.3.77 5 4000.2030.2410 SNAP TokenRing1/1/0


RSP-Core#sh mac-address add ?

% Unrecognized command

RSP-Core#sh mac-

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
lgijssel Thu, 11/01/2007 - 02:41
User Badges:
  • Red, 2250 points or more

Interesting hardware you have there.

Is this perhaps a cat 5xxx with an RSM module?

In that case, the RSM is in fact a router blade.

The command "sh mac-adress " is only found on switches. This info is there already but you need to get it from the supervisor which will be running CatOS.

http://www.cisco.com/en/US/docs/switches/lan/catalyst5000/catos/4.5/configuration/guide/5000_cfg.html


regards,

Leo

Actions

This Discussion