11-01-2007 01:43 PM - edited 03-03-2019 07:22 PM
I hope someone can please help me, I have a catalyst 3560 series switch that was bought at a auction and the switch did not have the ios installed on it, I was able to get the bin file loaded on it and can get access to it through the console port but from what i have been able to find out about it the switch should have a web interface gui to set it up with please help on getting it installed into the switch, thanks in advance Dan
11-01-2007 01:45 PM
Hi Dan
It depends what you loaded onto the switch. If you loaded just the .bin file then you can only configure if from the CLI.
If you loaded the .tar file then that includes the html pages etc. needed to configure the switch via the web interface.
Jon
11-01-2007 02:19 PM
How do i load the tar file into the switch is it loaded the same way as the bin file?
11-01-2007 03:03 PM
Dan
Attached is a link to 3560 configuration document that shows how to upload .tar file to switch.
HTH
Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: