Frame-Relay CIR,bc & be Configurations

Unanswered Question
Nov 1st, 2007
User Badges:

If a customer has subscribed for a CIR of 256 Kbps and a burst of 16 Kbps , what are the Values that i shall set for

frame-relay cir , frame-relay bc , frame-relay be and frame-relay mincir in map-class frame-relay.

are there any specific Ratios (comparing with cir given)for bc and be that we need to set.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
susheel.p Wed, 11/14/2007 - 21:32
User Badges:

Sir,

I read the PDF available on this site.but still one doubt i have.Customer has subscribed for access-rate of 64 Kbps and Burst of 16 Kbps.

If i set CIR of 64 Kbps , bc of 8 Kbps , what is the value that i shall set for be. is it 16 Kbps or 2 Kbps so that when multiplied by the Multiplication Value bet. CIR & bc which is 8 here , then it becomes 16 Kbps total.


can you please suggest the value that i shall set for be.


Edison Ortiz Thu, 11/15/2007 - 07:42
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

> what is the value that i shall set for be.


You don't necessarily need to set a value for be if the telco hasn't provided. From your post, they've only provided the bc.


Your bc value should be 16000



susheel.p Fri, 11/16/2007 - 02:44
User Badges:

i am on the Service Provider side i:e i have to set be value on my router interface for the customer,so what value for be shall i set in the map-class.

susheel.p Wed, 11/21/2007 - 03:18
User Badges:

i am on the Service Provider side i:e i have to set be value on my router interface for the customer,so what value for be shall i set in the map-class.



Actions

This Discussion