2811 - Flash (no device available)

Unanswered Question
Nov 2nd, 2007
User Badges:

Hi All


Just tried upgrading IOS on 2811 by putting CF card into reader on PC and copying IOS onto it.

PC reported CF needed formatting to use it so I formatted as FAT and copied IOS onto it.


Router boots up fine with new IOS image but a show flash command reports:


Router#show flash

%Error show flash: (No device available)


Any Ideas?



Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Fri, 11/02/2007 - 08:06
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


Have you tried just entering "dir" at the prompt to see where it thinks your image is.


Jon

anthonyfear Fri, 11/02/2007 - 10:26
User Badges:

I used a different flash card (but did exactly the same procedure) but this one works! So I'm sticking with the non cisco CF.



Thanks anyway.

Actions

This Discussion