11-02-2007 08:03 AM - edited 03-03-2019 07:23 PM
Hi All
Just tried upgrading IOS on 2811 by putting CF card into reader on PC and copying IOS onto it.
PC reported CF needed formatting to use it so I formatted as FAT and copied IOS onto it.
Router boots up fine with new IOS image but a show flash command reports:
Router#show flash
%Error show flash: (No device available)
Any Ideas?
Thanks in advance
11-02-2007 08:06 AM
Hi
Have you tried just entering "dir" at the prompt to see where it thinks your image is.
Jon
11-02-2007 10:26 AM
I used a different flash card (but did exactly the same procedure) but this one works! So I'm sticking with the non cisco CF.
Thanks anyway.
11-02-2007 07:04 PM
try this commande : dir flash:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide