Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
630
Views
0
Helpful
4
Replies

QSIG MGCP to H323

martin01
Level 1
Level 1

‎11-04-2007 12:07 PM - edited ‎03-15-2019 07:03 AM

Hi,

this is the situation.

MGCP:

1 PRI DMS-100 to PSTN

1 PRI QSIG to PBX (for internal call 1-7 xxx)

When I change the MGCP to H323.

PRI over PSTN, works fine

PRI for the PBX, doesn't works.

If I call from Cisco, no problem except the hangup (doesn't work). If I call from the PBX, sometime work with a delay (2-3 secondes).

I attach the config MGCP and H323.

Can you help me??

Thanks!

Martin

Labels:
Preview file
3 KB
Preview file
3 KB
0 Helpful
4 Replies 4

aalejo
Level 5
Level 5

‎11-05-2007 07:11 AM

Does not work means?

1.- Both PRI Layer 1 are down?

2.- Both Pri layer 2 are down?

3.- Layer 1 and 2 are up but no calls go through?

0 Helpful

martin01
Level 1
Level 1
In response to aalejo

‎11-07-2007 06:05 PM

2 PRI are up (lawer 1 and 2)

The PRI for the PSTN, I can make and receive many call, no problem with this part.

For the PRI to the PBX... I attach the debug

Preview file
35 KB
0 Helpful

aalejo
Level 5
Level 5
In response to martin01

‎11-08-2007 06:06 AM

You have a call loop.....

0 Helpful

martin01
Level 1
Level 1
In response to aalejo

‎11-13-2007 06:34 AM

Thanks. Other question...

I have extension 3xxx on my CCM and my PBX have 3xxx, 1-7xxx over PRI 0/0/1 and PSTN (for external call) on my PRI 0/0/0. I have difficult with my dial-peer. This is my last try. When I call from the PBX and PSTN I receive the dial tone.

dial-peer voice 4000 voip

destination-pattern ....

session target ipv4:172.27.2.10

dtmf-relay h245-alphanumeric

codec g711ulaw

!

dial-peer voice 1 pots

destination-pattern [4-5].........

direct-inward-dial

port 0/0/0:23

forward-digits 10

!

dial-peer voice 2 pots

destination-pattern 1[2-8].........

direct-inward-dial

port 0/0/0:23

forward-digits 11

!

dial-peer voice 3 pots

destination-pattern 011T

direct-inward-dial

port 0/0/0:23

forward-digits 12

!

dial-peer voice 4 pots

destination-pattern [1-7]...

direct-inward-dial

port 0/0/1:23

forward-digits 4

Thanks!

Martin

0 Helpful
Customers Also Viewed These Support Documents