cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
248
Views
0
Helpful
3
Replies

Is possible to configure NM-4B-S/T BRI for voice?

connect101
Level 1
Level 1

Hi,

Is it possible to configure a NM-4B-S/T for voice support?

I explain:

I want to use a NM-4B-S/T to connect to the PSTN on a c2811. But when I configure the dial-peer pots, there is no voice port.

Is it possible?

Thanks

3 Replies 3

Rob Huffman
Hall of Fame
Hall of Fame

Hi Solo,

Sorry, this card is a NM - Network Module and will not support Voice :( There are some VIC - Voice interface choices that will work listed in this doc;

http://www.cisco.com/en/US/products/hw/modules/ps5365/products_data_sheet09186a0080191d41.html

Hope this helps!

Rob

If I want to use 4 BRI for Voice, what is your suggestion?

Thanks

Either 2 x VIC2-2BRI-NT/TE, or an addon module for EVM, (that is useable only on 2821 and bigger router).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: