ericgarnel Mon, 11/05/2007 - 06:33
User Badges:
  • Gold, 750 points or more

Well,


You can plug in the console port with a serial connection and use hyperterminal, terraterm, minicom,etc


or connect to the service port over ip and use telnet (if enabled) or ssh


or connect via browser

virenderjaglan Tue, 11/06/2007 - 03:20
User Badges:

hi,


you can make connection between laptop and wlc via service port of wlc after configure service port with ip and you can open it by web browser https:// ip add of service port.


thanks

virender

dennischolmes Wed, 11/07/2007 - 04:26
User Badges:
  • Gold, 750 points or more

If you have not configured a different address on the service port. Use the default address of 192.168.1.1 to gain access. Make sure that your pc is setup with a static address in that subnet. To run the setup wizard the first time you use http after the first reboot the controller uses https for a secure session.

Scott Fella Sun, 11/11/2007 - 07:43
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

First of all, you will have to console in to confiugre the WLC. It is the management IP address you will use to configure via gui the WLC if on the network. Or else like the others stated, use the service port and connect your laptop to that with a static ip address.

Actions

This Discussion