bandwidth requirement between controllers in mobility group

Unanswered Question
Nov 5th, 2007
User Badges:

We have a potential project spanning two sites a few miles apart. We are hoping of putting 1 controller at each site in a single mobility group to provide AP failover if one controller is to fail. We are planning on a total of 25-30 APs, roughly half at each site.


Questions:

Whats the minimum bandwidth required between sites?

If bandwidth isn't adequate can this be done with both controllers at one site and H-Reap access points for the other site? Am I correct in thinking that you can have no more than 8 H-Reap access points per WLAN (16 Reap APs per WLAN)?


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
irisrios Mon, 11/12/2007 - 10:31
User Badges:
  • Silver, 250 points or more

It's better to have one controller at each site. Minimum bandwidth requirement would be 128 kbps and not more than 100 ms delay in this WAN link.

yubago@ctgmt.com Mon, 11/12/2007 - 15:07
User Badges:

Thanks! I think it will be fine. I was more worried about the event of a failed controller which would cause more traffic between the other APs and the backup controller at the other site. However with all the APs in H-Reap local switching mode it should work.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode