"ignoredisplayieinconnect" endpoint used on CallManager EURO PRI gateway

Unanswered Question
Nov 6th, 2007

Can anybody shed any light on the "ignoredisplayieinconnect" endpoint that we seem to have setup on our Callmanager here in the office? (v3.3)

Allegedly these endpoints are needed because the check-boxes for "Redirecting Number IE Delivery - Inbound/Outbound" dont always work - thus the endpoint description needs to be explicit.

we seem to have one of these endpoints on EACH CMM module where we have endpoints that handle in/outbound calls.

Was this just a quirk of v3.3....?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bwilmoth Tue, 11/13/2007 - 06:54

If specified, CCM will only ignore the Display IE in the received CONNECT message. It will not affect the Display IE

received in other I messages.


This Discussion