Switch problem

Unanswered Question
Nov 6th, 2007

Switch 24 prot is not working although I restart that switch by unplug and plug the power again!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
spremkumar Wed, 11/07/2007 - 02:21


In which switch model you are facing this problem ?

can you login to the switch and post the output of show interface fastethernet x/24 and show version ?


sophaunsim Wed, 11/07/2007 - 20:52

Model Cisco Catalyst 2950 Series Switches! all the hosts can't communicated to each other!

intelide3 Wed, 11/07/2007 - 21:42


by restarting (unplug-plug) the switch doesnt mean that it will lost the config.

do you have access to the switch to see its switch-port vlan membership config? check their status - cables?


pls rate :)

ilnaiduccna Wed, 11/07/2007 - 22:08


As your info. your using 2950S, what are the ports blinking status eithere keep on orage / green, are you sure vlan membership still is there or not, can you post the sh run it may help in this forum.




This Discussion