11-06-2007 07:50 PM - edited 03-03-2019 05:42 AM
Switch 24 prot is not working although I restart that switch by unplug and plug the power again!
11-07-2007 02:21 AM
hi
In which switch model you are facing this problem ?
can you login to the switch and post the output of show interface fastethernet x/24 and show version ?
regds
11-07-2007 08:52 PM
Model Cisco Catalyst 2950 Series Switches! all the hosts can't communicated to each other!
11-07-2007 09:42 PM
hi,
by restarting (unplug-plug) the switch doesnt mean that it will lost the config.
do you have access to the switch to see its switch-port vlan membership config? check their status - cables?
HTH
pls rate :)
11-07-2007 10:08 PM
Hi,
As your info. your using 2950S, what are the ports blinking status eithere keep on orage / green, are you sure vlan membership still is there or not, can you post the sh run it may help in this forum.
Regards,
Naidu.
11-07-2007 10:53 PM
blinking status eithere keep on orange!
11-07-2007 11:07 PM
Hi,
Check is there may be duplex mismatch.
Regards,
Naidu.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: