×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

C2801 E1 to Asterisk using SIP

Unanswered Question
Nov 6th, 2007
User Badges:

Hi All


I'm a SIP newbie so I'd really appreciate some help. I have a Cisco 2801 running Advanced IP Services 12.4(17). I am trying to get it to act as a SIP gateway between a server with a Dialogic D/600JCT-1E1 card (E1 card) and another server running Asterisk.


I seem to be able to establish the call from the E1 card to the Cisco router OK, as I see the channels come up and go down again at the end of the call. However no connection attempt is made with the Asterisk server. When I look at the call history on the router there is no mention made of VOIP calls - just the TELE calls.


Can anybody suggest what I might be doing wrong. I have attached my config for reference.


Thanks in advance!



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
limbrickh Tue, 11/06/2007 - 22:08
User Badges:

I've found the problem. I did not have any POTS dial-peers defined for my E1 connection. I added...


dial-peer voice 4 pots

destination-pattern 4...

direct-inward-dial

port 0/1/0:15

prefix 4


and it started working.

Actions

This Discussion