NAC Issue

Unanswered Question
Nov 7th, 2007

hello guys;

I have nac 3310 with lite manager license,

there is no any switch managment menu on the CAM.

how can i handle snmp traps from swiches without this menu?

or is any other type of development?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
pmccubbin Wed, 11/07/2007 - 04:25

Hi Ehsan,

Please take another look in the CAM and let's be clear about the fact you are doing an Out-of-Band implementation of NAC.

Look for Switch Management-->Profiles.

You can use the default profile and add your first switch. You must then add a switch profile for each model of Cisco switch you manage.

Make sure that you configure the switch model, the SNMP port, and the SNMP read/write community strings to match the configuration on each switch.

Hope this helps.



pmccubbin Wed, 11/07/2007 - 06:21

Hi Ehsan,

Here's a dumb question which I should have asked you first: Have you added the license for a CAS?

You need to add the OOB CAS to your CAM and then you can manage a switch.

Hope this helps.



paqett001 Sun, 11/11/2007 - 21:04

Sounds like the same problem I had. I opened a TAC case and I was issued a new license. Both licenses need to be associated to the MAC address of the CAM. I had one associated to the CAS and one to the CAM. I understand it is a pretty common problem.


This Discussion