11-07-2007 05:22 AM - edited 03-03-2019 05:43 AM
I have been trying with little success to reset the switch identity type in CiscoWorks from a "Cisco 3750 Stack" to a "Cisco 3750-24ts". Every time it is modified, after a few seconds the type switches back to the "stack" type. I have even tried removing the device(s) and re-adding them to CW but the same thing occurs. The unit is in fact not a stack but a single switch unit. Is this behavior being caused from the unit's IOS? ((C3750-IPBASE-M), Version 12.2(25)SEB1) or is there a configuration item that I have missed that should allow it to appear as a single unit to CW?
11-07-2007 06:47 AM
You might want to post this in the Network Management Forum
11-08-2007 11:48 AM
In the configuration of the switch do you have switch 2 provision (switch). Perhaps it was stacked at one point and you will have to get rid of the statement of switch 2 in the configurations.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide